I started with a simple cylinder and added intersections to the outside using the insert edge loop. I then used the move tool to stretch out the edges to suit the form of a mug.I then inserted another edge loop on the top of the cylinder. with the new smaller face on top, I was able to move the face down to the bottom of the cylinder to give the inside of the mug. I then inserted edge loops on the inside of the mug to match the ones on the outside. I then used the move tool and matched them up to the outside edges. to do this accurately I used the orthographic view on the left. the image above shows the end product.I then proceeded to add a torus that would act as the handle for the mug. to make it look more like a handle I deleted half of the torus. after deleting i lined up the torus with the mug to were the handle would be to give the image shown above.Finally I edited some of the vertexes on the torus so they wouldn’t be visible inside the mug and after all that I used the smooth operation tool to add more smooth operations to both objects so they were less flat.Final product.
